Satoshi Nakamoto Blog
Image default
3d Printer hacks bowden extruder flexible filament hot end tpe TPU

A Better Bowden Drive for Floppy Filaments


You might not think to use the word “rigid” to describe most 3D-printer filaments, but most plastic filaments are actually pretty stiff over a short length, stiff enough to be pushed into an extruder. Try the same thing with a softer plastic like TPE, though, and you might find yourself looking at this modified Bowden drive for elastomeric filaments.

The idea behind the Bowden drive favored by some 3D-printer designers is simple: clamp the filament between a motor-driven wheel and an idler to push it up a pipe into the hot end of the extruder. But with TPE and similar elastomeric filaments, [Tech2C] found that the Bowden drive on his Hypercube printer was causing jams and under-extrusion artifacts in finished prints. A careful analysis of the stock drive showed a few weaknesses, such as how much of the filament is not supported on the output side of the wheel. [Tech2C] reworked the drive to close that gap and also to move the output tube opening closer to the drive. The stock drive wheel was also replaced with a smaller diameter wheel with more aggressive knurling. Bolted to the stepper, the new drive gave remarkably improved results – a TPE vase was almost flawless with the new drive, while the old drive had blobs and artifacts galore. And a retraction test print showed no stringing at all with PLA, meaning the new drive isn’t just good for the soft stuff.

All in all, a great upgrade for this versatile and hackable little printer. We’ve seen the Hypercube before, of course – this bed height probe using SMD resistors as strain gauges connects to the other end of the Bowden drive.




Source link

Related posts

Laser Arm Cannon Scares More than Metroids

satoshi

Google’s new Cloud TPU Pods offer an on-demand AI supercomputer

satoshi

Dancing Arrows To Break Your Brain

satoshi

3D Printing A Lifting Body Aircraft

satoshi

Wind Turbine Pushes Limits Of Desktop 3D Printing

satoshi

How Not to Design a 3D Printed Belt Clamp

satoshi